Honeywell Touchpoint Plus Technical Handbook page 138

Parameter Name
Gas Type Gas Type
STEL Interval * 10, 15, 20, 25, 30
The gas concentration within the dead
Lower Zero Dead
band limit will be suppressed to default
Band
base concentration. i.e. if the gas
concentration is between the (default base
concentration
Upper Zero Dead
(default base concentration + upper dead
Band
band), then the reading will be the default
base concentration.
Over-range gas concentration limit. This
Gas Over Range
parameter is used to generate over-range
Limit
warning.
Gas Under Range
Negative reading limit
Limit
Span Calibration
Target span gas concentration
Conc.
Signal Under Range Lower allowable limit for the input signal
Limit from the sensor/detector.
Signal Over Range Upper allowable limit for the input signal
Limit from the sensor/detector.
minimum inhibit current from mA output
Signal Inhibit Min.
sensor
maximum inhibit current from mA output
Signal Inhibit Max.
sensor
minimum fault current from mA output
Signal Fault Min.
sensor
MAN0984_Iss 4_01/19
Pt. No. 3011M5001
Parameter
Description
lower dead band) and
Configurable Parameter Reference Guide
Applies Read/
Range
to Write
mA Input R/W 0~2
10, 15, 20, 25,
mA Input R/W
30
mA Input R/W -20 ~ 0 % FSD
mA Input R/W 0 ~ 20% FSD
100% ~
mA Input R/W
110%FSD
mA Input R/W -24% ~ 0%FSD
mA Input R/W 20 ~ 100 %FSD
mA Input R/W 0
mA Input R/W 20~24mA
mA Input R/W 0~24
mA Input R/W 0~24
mA Input R/W 0~24
138
Default Value Remark
Depend on Gas Name.
Gas Type Toxic(0) O2(1) Flammable(2)
Flame(3)
15 Minute
0 In case O2 :20.9%
0 In case O2 :20.9%
110 %FSD
-10 %FSD
Oxygen needs just span
50% of Full range calibration. No zero
calibration required.
To diagnose the mA input
0
current
Depend on To diagnose the mA input
detector current
if min/max is set to zero, mA
1.9 mA input board will not detect
inhibit condition.
2.1 mA
if min/max is set to zero, mA
0.0 mA input board will not detect
fault condition.
Technical Handbook
Touchpoint Plus