Installing Or Changing A Hard Drive - Swann DVR4-1000 DVR4-1000 Operating Instructions Manual

4 channel digital video recorder
Hide thumbs Also See for DVR4-1000 DVR4-1000:
Table of Contents

Advertisement

Installing or Changing a Hard Drive

IMPORTANT NOTE: The following instructions are for installing or changing the
hard drive. If your DVR4-1000™ already has a hard drive pre-installed disregard
these steps.
Installing / Changing a Hard Drive in the DVR4-1000™
1. Ensure the DVR4-1000™ is unplugged and removed from mains power.
Remove
2. Locate and remove the screws
indicated in the diagram. There are
7 screws in total.
Remove
4. Locate and remove the screws
holding the hard drive in place
shown in the diagram. There are
4 screws in total. Secure the hard
drive before unscrewing from the
DVR to avoid dropping / damage.
6. Replace the current Hard Drive and plug in SATA and power cables as shown
in step 5.
7. Screw in the hard drive to the bottom of the case.
8. Replace the top of the case.
9. Screw in the remaining 7 screws to the sides and top of the DVR.
10
10
3. Pull up the top half of the DVR
case from the back and remove.
5. Remove the SATA and power
cable from the back of the Hard
Drive.
Screen Menu
Border: Applies a border between the cameras in multi camera view.
Video Adjustment: Adjust the display to fi t on your TV monitor.
Auto Switching: When active, in live view mode, the DVR will automatically
switch between camera channels in full screen mode. Set the delay from 1-10
seconds between changes or Off. To activate Auto Switching, press the button
marked
when viewing your cameras. Press the
Switching.
Audio Menu
Record: Set to on to record audio from the Audio Input on the back of the DVR.
Mute: Turns Audio on or off when viewing or recording cameras. Alternatively,
press the Mute button to turn Audio on or off while viewing your cameras.
Input Volume: Move the slider to change the volume of the audio recorded.
Output Volume: Move the slider to change the volume of audio playback.
The Screen menu adjusts the display of
cameras in the main camera view.
button again to stop Auto
The Audio menu sets the audio
recording and volume options.
Note: You must have a camera with
audio or a microphone to record or
monitor audio.
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw242-du2Sw244-duxSw244-dum

Table of Contents