Installing/Changing The Hard Drive; Installing/Changing The Hdd - Swann DVR8-2500 Operating Instructions Manual

Installing/Changing the HDD

Note: the following instructions are for installing or changing the hard drive. If
your DVR already has a hard drive pre-installed disregard these steps.
1. Ensure the DVR is unplugged and removed from mains power.
2. Locate and remove the 3 screws on the
rear of the DVR.
Remove
Back of DVR
4. Locate the 4 screws holding down the
hard drive stand.
Remove
Now remove the 4 screws attaching the stand
pieces to the hard drive.
Remove
6. Replace the Hard Drive and plug in the SATA and the power cable as shown in step 5.
7. Screw in the hard drive to case as in step 4.
8. Replace the top of the case.
9. Screw in the remaining screws to the sides and back of the DVR as in step 2.
3. Pull up the top case of the DVR.
5. Push the metal clip on the SATA cable
(single RED or ORANGE cable) to unplug
the cable from the hard drive. Unplug the
power cable (2 BLACK 1 YELLOW and
1 RED cable) from the back of the Hard
Drive.
SATA Cable
Power Cable
39