Room Transfer - Invacare EC-Track Installation & Technical Description

Rails
Parallel: L-Profile
Traverse: L-Profile

2.3 Room Transfer

Room transfer with two hoists
Room transfer can be done by using two Robin hoists;
one in each room. To ease this operation, an Invacare
room-to-room trolley is used.
Room transfer is possible in both single- or room covering
installations. It is important that the rails are located
as close to the doorway as possible. When installing a
room covering rail system intended for room transfer,
the traverse rail must be installed perpendicular to the
wall with the doorway. The distance between the two
end stop buffers must not exceed 600 mm. To obtain the
best possible result during room transfer, there must be a
minimum distance of 1.85 m between the floor and the
1586749-C
Combination
Under-hung traverse:
Between-hung traverse:
Partly between-hung
traverse:
Possible combinations
underside of the hoist. This must be kept in mind during
installation of the rail system.
Room transfer with transit (transit coupling)
As an alternative the room transfer can be achieved by
an installed transit coupling.
The coupling can be used to connect either two traverse
systems or one traverse system and one single rail system.
The coupling is operated electrically by a control button
mounted on the wall. The coupling is delivered with a
standard length of 800 mm.
For further information see chapters 2.4 Rails, Brackets &
Accessories, page 8 and 3.10 Transit coupling, page 22.
Rail system
7