IBM Aptiva Series Hardware Maintenance page 65

Table 2- 1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps
071
CMOS Battery Bad
072
CMOS Checksum Error
080
PCI Device Error
081
System Resource
Conflict
082
IRQ Setting Error
083
Expansion ROM
Allocation Fail
180
Onboard Serial Port 1
IRQ Conflict(s)
181
Onboard Serial Port 2
IRQ Conflict(s)
2-12
Action/FRU
Enter BIOS Setup, then reboot system.
RTC battery. See ""RTC Lithium Battery"
on page 4-28.
System board
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
RTC battery. See ""RTC Lithium Battery"
on page 4-28.
System board
Remove the non-factory-installed
adapter card and reboot system.
PCI card
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.