Jenn-Air JER8500AAA Use And Care Manual page 30

Electric range with self-cleaning oven
Table of Contents

Advertisement

AB01IT SERVIq ; E
Oven door will not
1. Self-clean was not properly set.
1. Follow instructions on pages 17 and 18.
lock for self-clean.
2. Oven door is not closed.
2. Be sure door is properly closed.
Oven door will not
1. Clean cycle ended less than one
1. Allow about 1 hour for oven to cool. Door can be
unlock after clean
hour ago.
unlocked when LOCK indicator is no longer dis-
cycle or if accidently
played.
locked during baking.
2. Oven hot enough to engage internal
2. Allow oven to cool until LOCK indicator no longer
lock, if accidently locked during
is displayed. To speed cooling, allow a fan to blow
baking,
on oven door.
Moisture condensa-
1. Window may fog when cooking food
1. This condition is normal.
tion on oven window,
high in moisture.
2. Used a cloth saturated with water to
2. Wring excess water from cloth before cleaning.
clean window.
Oven light does not
1. Oven light bulb is loose or burned
1. Check or replace bulb.
turn on.
out.
2. Light switch in the OFF position.
2. See page 15 for instructions.
Strong odor when
1. "Burning off' of manufacturing oils
1. This is a normal odor for a new range and will
oven is turned on.
or insulation,
disappear after a few uses. A clean cycle will
speed up the process.
2. Food soil.
2. Use self-clean feature.
"F" plus a number
This is called a FAULT CODE. If a fault code appears in the display and beeps sound, press
appears in display,
any pad except the CANCEL and • or • pads. If the fault code and beeps continue,
disconnect power to the appliance and call an authorized servicer. If the fault code and beeps
continue, disconnect power to the appliance. Wait a few minutes then reconnect power to the
appliance. If the fault code and beeps still continue then call a factory authorized servicer or
1-800-688-1100.
If the oven is heavily soiled, excessive flare-ups may result in a fault code during a clean
cycle. Press any pad except the CANCEL and • olh_pads
and allow oven to cool for one
hour then reset the clean cycle.

Advertisement

Table of Contents
loading

Table of Contents