All-Wheel Drive - Suzuki XL7 Owner's Manual

To disconnect the jumper cables from both
vehicles, do the following:
1) Disconnect the black negative (–) cable
from the vehicle that had the dead bat-
tery.
2) Disconnect the black negative (–) cable
from the vehicle with the good battery.
3) Disconnect the red positive (+) cable
from the vehicle with the good battery.
4) Disconnect the red positive (+) cable
from the other vehicle.
5) Return the fuse block cover to its origi-
nalposition.

All-Wheel Drive

If you have an all-wheel-drive vehicle, be
sure to perform the lubricant checks
described in this section. However, there
are two additional systems that need lubri-
cation.
Transfer Case (Power Transfer Unit)
When to Check Lubricant
Refer to the Maintenance Schedule to
determine how often to check the lubricant.
Refer to "Scheduled Maintenance" in
"Maintenance Schedule" in the "Mainte-
nance Schedule" section.
How to Check Lubricant
A. Fill Plug
B. Drain Plug
SERVICE AND APPEARANCE CARE
To get an accurate reading, the vehicle
should be on a level surface.
If the level is below the bottom of the filler
plug hole, you'll need to add some lubri-
cant. Add enough lubricant to raise the
level to the bottom of the filler plug hole.
What to Use
Refer to the Maintenance Schedule to
determine what kind of lubricant to use.
Refer to "Recommended Fluids and Lubri-
cants" in "Maintenance Schedule" in the
"Maintenance Schedule" section.
Carrier Assembly-Differential
(Rear Drive Module)
When to Check and Change Lubricant
Refer to the Maintenance Schedule to
determine how often to check the lubricant
and when to change it. Refer to "Sched-
uled Maintenance"
Schedule" in the "Maintenance Schedule"
section.
1765710
in "Maintenance
5-22