To program an ACRO, aircraft type gyro:
CURVE
1. Touch
to open the custom curve mix.
2. Assign the input channel for the gyro. For example, if the gyro is installed to assist the aileron
channel, select Aileron.
3. Assign the output channel for the gyro, for example, the Gear channel. The gain signal from the
gyro must be plugged into the designated port to function properly; in this case, the gear port.
4. Add the desired gyro gain values to the points on the curve.
5. To add more points on the curve, move the master control input to the desired location for the
new point on the curve, and touch the
6. Assign the switch positions to activate the gyro curve. The curve is active when the box is solid.
Add Pt
button.