Installing The Optional Boards - Sony HDCU-900 Series Installation And Maintenance Manual

1-6. Installing the Optional Boards

The following optional boards can be available for this unit. Use different slots for each board and set the
switches respectively.
For the details, refer to Section 2-1, "Setting the System Format".
Model
SD Analog Interface Unit HKCU-901
HD Analog Interface Unit HKCU-902
Frame Rate Converter Unit HKCU-903 FC-83
Line Converter Unit HKCU-904
*1 : for UC
*2 : for CE
m
When installing the optional boards, make sure of the following items.
. When installing the optional boards, be sure to start installation from the second slot from the top on
both the front side and rear side. Never install an optional board in the third slot from the top leaving
the slots blank without installing the board.
. Be sure to install the HKCU-901 of the same destination as the HDCU-900.
. Be sure to install the HKCU-901/903/904 into the same slot on the front and rear sides.
. Do not install two or more of the same circuit boards at the same time.
HDCU-900 IMM
Board Board
(slot in the front) (slot in the rear) installed
*1 *2
IF-789A /789P VDA-57
_ ADA-59
SDI-54B
LC-41 SDI-54C
1-6. Installing the Optional Boards
Slot into which boards are
Third slot from the top slot
Second or third slot from the top slot
Second slot from the top slot
Second or third slot from the top slot
1-23 (E)