System Setup; Setting The System Format - Sony HDCU-900 Series Installation And Maintenance Manual

2-1. Setting the System Format

This unit can support input and output of multiple formats. It can also support various types of user's
format by installing the optional circuit boards.
The slots to which the circuit boards are inserted and the internal switches of the unit differ depending
upon the system used. They need to be set according to the system used.
HDCU-900 and list of optional boards
Model name
HDCU-900
SD Analog Interface Unit HKCU-901
HD Analgo Interface Unit HKCU-902
Frame Rate Converter Unit HKCU-903
Line Converter Unit HKCU-904
*1 : for UC
*2 : for CE
m
. Be sure to install the HKCU-901 of the same destination as the HDCU-900.
. When the HKCU-901 is going to be installed, confirm beforehand that the RC-86 board is installed in
the second slot from the top on the front side, the DIF-102 board or the HKCU-902 is installed in the
second slot from the top on the front side.
. When installing the optional boards, be sure to start installation from the second slot from the top on
both the front side and rear side. Never install an optional board in the third slot from the top leaving
the slots blank without installing the board.
. Be sure to install the HKCU-901/903/904 into the same slot on the front and rear sides.
. Do not install two or more of the same circuit boards at the same time.
HDCU-900 IMM
Section 2

System Setup

Board name Board name
(Slots on the front) (Slots on the rear)
DPR-163 SDI-54A
RC-86 DIF-102
AT-141 _
IF-789A *1 /789P *2 VDA-57
_ ADA-59
FC-83 SDI-54B
LC-41 SDI-54C
Slot to be installed
Fixed to the top most slot
Second or third slot from
the top
Fixed to the bottom most
slot
Third slot from the top
Second or third slot from
the top
Second slot from the top
Second or third slot from
the top
2-1 (E)