Using The Ignition Sense And Other Options - Kenwood TK-7160 Modification Information

14. Configure the Function Port window.
Select "None" from the External Devices (Port 1
to 2) and External Devices (Port 3 to 8)
dropdown lists, and check the Ignition Sense
checkbox.
Figure 2-33 Function Port Window
2.13 Using the Ignition Sense
and Other Options
2.13.1 Using the Ignition Sense
1. Check the Function Port window > Ignition Sense
checkbox in KPG-99D.
2. Remove R95 on the side A of the TX-RX PCB.
3. Connect the KCT-39 cable to the transceiver.
Refer to 2.3 Ignition Sense Cable for instructions on
how to connect the cable.
MOD (K)/Ver. 2.00
2 CONNECTING OPTIONAL DEVICES
4. Connect the KCT-39 cable to the Ignition Line of
the car.
5. Connect the pin 2 (pink) of the KCT-39 cable to the
Ignition line of the vehicle.
2.13.2 Using Ignition Sense with the
Scrambler Board
The Scrambler board occupies CN3 having the Ignition
Sense port when the Scrambler Board is installed.
Therefore, the KCT-39 cable cannot be used.
The pad for the Ignition Sense is prepared on the
TX-RX PCB so that the Ignition Sense and Scrambler
Board can be used at the same time by soldering a
normal cable to the Ignition Sense pad.
Wires should not be stuck between the top panel and
TX-RX PCB.
The following figures show the wiring example.
Confidential 51
CONTENTS