Configuration Using Kpg-99D - Kenwood TK-7160 Modification Information

2 CONNECTING OPTIONAL DEVICES
7. Dress the cables soldered to the Scrambler Board
as shown in the following figure.
Speaker wire cable
below scrambler
wiring
Note:
The speaker cable wires must be positioned under the
Scrambler cables.
Scrambler cables should not be dressed between the shielding
cover and PCB.
8. Reassemble the shielding plate, and re-install the
screws and packing.

2.8.2 Configuration using KPG-99D

ANI Board information can be written to the transceiver
by using KPG-99D after installing the board in the
transceiver. Follow the procedure below to write ANI
Board information to the transceiver.
1. Run KPG-99D.
2. Select the Program pulldown menu > "Read Data
from the Transceiver". The "
can be clicked to read data from the transceiver.
The Read Data from the Transceiver dialog box
appears on the display.
Figure 2-20 Read Data from the Transceiver Dialog Box 1
3. Click the "Read" button.
KPG-99D starts reading configuration data from the
transceiver.
30
CONTENTS
Keep scrambler
wiring away from
shielding cover.
" icon in the tool bar
Figure 2-21 Read Data from the Transceiver Dialog Box 2
4. Select the Edit pulldown menu > "Function Port".
The Function Port window appears on the display.
Figure 2-22 Function Port Window 1
5. Select the External Devices (Port 3 to 8)
dropdown list > "Scrambler".
Refer to the instruction manual supplied with the
Scrambler Board for instructions on how to
configure the Scrambler Board.
Figure 2-23 Function Port Window 2
Confidential MOD (K)/Ver. 2.00