Kds-100 - Kenwood TK-7160 Modification Information

2 CONNECTING OPTIONAL DEVICES
3. Insert KCT-18 into KCT-39.
Insert KCT-18 into the 2nd pin of the KCT-39 cable.
4. Connect the other end of the KCT-18 cable to the
Ignition Line of the vehicle.
Note: Refer to 2.13 Using the Ignition Sense and Other Options on
page 51 when the KCT-18 is used with the KDS-100 or
KGP-2A/ KGP-2B.

2.4 KDS-100

A data terminal (KDS-100) used for establishing data
communications can be connected to the TK-7160/
TK-8160. This section describes how to connect
KDS-100 to the TK-7160/ TK-8160.
2.4.1 Description
This transceiver can be configured to work with a data
terminal to establish data communications. This
transceiver is equipped with serial input/ output ports
and data modulation input/ output ports.
TK-x180 series and TK-x60G series transceivers
support KDS-100.
Also, KDS-100 is equipped with DSP (Digital Signal
Processing), general purpose serial ports, and general
purpose I/O ports. Thus, it has been designed to work
with various peripheral devices. Although we provide
the FPU (programming software), we do not develop
computer software to run on a PC.
There are 2 types of protocols: serial protocol and air
protocol. The TK-7160/ TK-8160 support the air
protocol.
16
CONTENTS
2.4.2 Features
• Full-dot display (240 x 64 dots) with backlight
function
• Programmable PF keys (Programmable Function
keys) with backlight function
• The following external terminals are available.
- Serial communication terminal
- I/O control terminal
- Data modulation I/O terminals
• The following internal terminals are available.
- Two general purpose serial terminals (RS232C
level) (Reserved for future use)
- PC/ AT keyboard input terminal (Reserved for
future use)
- NMEA0183 GPS receiver connection terminal
(Reserved for future use)
- Input port for differential GPS signal (Reserved
for future use)
- Two clock synchronizer serial input ports (for
low-cost card reader) (Reserved for future use)
- General purpose I/O control ports
- External SP port (Reserved for future use)
• DSP is installed to support higher speed data
communication for future.
• Real time clock
• Battery status memory for data communication
• Tri-color LED for indicating communication port
status
• Modem output level adjustment function using
commands generated from electronic source
(PC & Panel Tune)
• Firmware update function using a flash ROM
• Supports the following protocols:
- FleetSync serial protocol (for use with
conventional transceivers or LTR transceivers
supporting FleetSync)
- Fleet-Sync protocol capable (for use with Non-
FleetSync capable LTR/ Conventional
transceivers can be interfaced with FleetSync
compatible transceivers)
• Internal alarm to notify of message reception
• Additional message functions using FleetSync
Short Message and Long Message
Confidential MOD (K)/Ver. 2.00