Txs (Output) - Kenwood TK-7160 Modification Information

1 PORT FUNCTIONS

1.3.20 TXS (Output)

TXS (Output) can be assigned to Port 1 to Port 8.
The port logic level goes Low while the transceiver is
transmitting. On the other hand, the logic level goes
High while the transceiver is receiving.
This function can be used for KDS-100 and KGP-2A/
KGP-2B.
KDS-100 and KGP-2A/ KGP-2B recognize the
transceiver's status by checking the status of this port.
1.3.21 Scrambler Code (Output)
Scrambler Code (Output) can be assigned to Port 1 to
Port 8.
A scrambler code can be configured by combining the
following 4 codes: Scrambler Code 1 to Scrambler
Code 4.
The code selected from KPG-99D or using keys is sent
in hexadecimal format from the port assigned to
Scrambler Code1 (Output) to Scrambler Code 4
(Output) of Function Port.
Table 1-6 Scrambler Code
Scrambler Code # (Output)
Code
Code 4
1 0
2 0
3 0
4 0
5 0
6 0
7 0
8 0
9 1
10 1
11 1
12 1
13 1
14 1
15 1
16 1
0 = Low Level 1 = High Level
8
CONTENTS
Code 3 Code 2 Code 1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
1.3.22 Scrambler (Output)
Scrambler (Output) can be assigned to Port 1 to
Port 8.
This port level is Low if the Scrambler is enabled for
the current channel.
1.3.23 Emergency for ANI board
(Output)
Emergency for ANI board (Output) can be assigned to
Port 1 to Port 8.
This port logic level goes Low when a key and port
configured for Emergency is pressed for a duration
longer than the Emergency-key Delay Time.
Emergency-key Delay Time can be configured in the
Emergency Information window.
This function does not activate if no data is configured
for Emergency ID.
1.3.24 PTT (Output)
PTT (Output) can be assigned to Port 1 to Port 8.
The port logic level goes Low when the PTT switch is
pressed.
0
1
1.3.25 Status Message (Output)
0
1
Status Message (Output) can be assigned to Port 1 to
0
Port 8.
1
The logic level can be toggled between High and Low
0
depending on a received status when the transceiver
1 receives a FleetSync Status Message.
0
Status Message (Output) can be configured in the
FleetSync window > Target tab.
1
0
Note: If Status Message is selected by using KPG-99D, the
1 Status Memory (Status Message) checkbox will be active.
If Status Memory (Status Message) is enabled, the status
0
of the Status Memory port will be retained after the
transceiver is turned OFF. However, this function can be
1
configured only with KPG-99D version 1.30 or later.
0
1
Confidential MOD (K)/Ver. 2.00