Flueing Options; Horizontal Terminations (Mock Chimney); Vertical Terminations (Mock Chimney) - Rinnai Ember Series Installation Manual

Flueing options

Horizontal terminations (mock chimney)

Dimensions are in mm unless otherwise stated
2 m max.
4 3
Important
The horizontal flue length must
not be greater than the vertical.
3
255 245-410*
Flue cowl slides depending on wall thickness
2
1
20
400
Important notes
• For the horizontal flue terminal to comply with the required flue clearances, and to fit
under a 2.4 m eave, the maximum the fire can be installed above the floor is 400 mm.
Check clearances first before installation.
The horizontal run of flue pipe must have a 20 mm rise for every 1 m towards the flue
•
termination. NEVER allow the flue pipe to run downwards towards the flue terminal. A
downwards slope can trap heat and become a fire hazard.
• The horizontal flue length must not be greater than the vertical.
32 | Ember Installation Guide: 12890-B 02-18
5 & 6
Flue components
1. Ember adaptor (R3653)
Refer p. 30 for clearance to
combustible information for
the Ember adaptor.
2. Mock chimney horizontal
flue kit (R3654)
3. Flue pipe(s) 150-1000 mm
4. Flue elbow 90 ° (R3643)
Max. number of 90 ° bends
= one.
5. Horizontal flashing kit
(R3646)
6. Horizontal wall terminal
(R3650)
Flueing options

Vertical terminations (mock chimney)

Dimensions are in mm unless otherwise stated
2 m max.
4
2
4
2
3
2
2
3
2
1
20
400
Flue components
1. Ember adaptor (R3653)
Refer p. 30 for clearance to
combustible information for the
Ember adaptor. N.B: Can't be
more than 600 mm maximum, as
shown, due to the heat from the
colinear flexi flues.
Flue pipe(s) 150-1200 mm or
Flue extension(s)
If doing a straight short vertical
flue (no bends) for a single
storey dwelling the mock
chimney vertical flue kit 3.6 m
can be used (R3665).
2. Flue elbow 45 ° (R3642)
Maximum number of 45 ° bends
= 2
3. Roof cowl (R3651)
Ember Installation Guide: 12890-B 02-18 | 33