Table of Contents
Advertisement
7.5
Install an SLite tile
What has to be done ?
Installing an SLite tile into a LED-wall in a secure manner. This can only be done via back and front access at the same time. At
least three qualified persons are required to get the job done. Two persons at the front and one at the rear of the LED-wall.
C
AUTION
persons, which are thoroughly familiar with the product and all of the proper safety checks of this product.
To do otherwise increases the risk of hazard and injury to the user.
Necessary tools
•
Scaffold or Z-lift.
•
13 mm nut driver.
•
10 mm nut driver.
•
Hoisting crane.
•
Safety cable.
Necessary parts
Four M8 nuts.
How to install an SLite tile into a LED-wall ?
1. Read and heed the servicing safety instructions.
2. Build a solid scaffold at the rear of the LED-wall or use a Z-lift to access the tile in case there is no frame provided to the rear of
the LED-wall with service access.
3. Build a solid scaffold in front of the LED-wall or use a Z-lift to access the tile.
Warning: Both hands must be free for accessing a tile in a LED-wall. Therefor the use of a ladder to access a tile is forbidden.
Only a solid scaffold or a Z-lift is allowed.
4. Lift up the SLite tile at the height of the mounting place and install a safety cable around one of the tile hoisting eyes of the tile
and the frame of the LED-wall.
Image 7-6
5. Gently guide the SLite tile into position and keep pushing the tile in its place.
Caution:
Two persons at the front of the LED-wall must press the SLite tile into the LED-wall while the person at the rear fasten
the tile. This to prevent that the SLite drops out of the LED-wall.
R5976575 FIXED SLITE DISPLAY 08/03/2006
:
The following procedure must be performed by minimum three authorized and qualified technical
7. Servicing
41
Advertisement
Table of Contents
