Table of Contents
Advertisement
7.2
Remove the re-sync unit
Necessary tools
10 mm nut driver.
How to remove the re-sync unit of an SLite tile ?
1. Release the four bolts (Q) of the re-sync unit (R), using a 10 mm nut driver.
Image 7-1
2. Gently pull the re-sync unit about 25 cm out of the tile.
3. Disconnect the internal power cable (P) and data cable (D) between the SLite tile and the re-sync unit.
P
Image 7-2
To perform a "hot swap" of the SLite tile you can remove the re-sync unit without disconnecting the waterproof
power and data plugs from the re-sync unit. So, the data path and power branch is not interrupted, which
ensures that the rest of the LED-display remains active.
R5976575 FIXED SLITE DISPLAY 08/03/2006
R
D
Q
7. Servicing
37
Advertisement
Table of Contents
