Table of Contents
Advertisement
2. Installation requirements
2.2
Electrical requirements
Power requirements
One SLite tile requires 200-240 VAC, 50–60 Hz, 3 amps @ 230 VAC. Each SLite tile has a power loop through connector. However,
MAXIMUM 3 SLite tiles may be connected in parallel. So, one power source cable has to be provided per 3 tiles. Every power
source cable should be protected by a circuit breaker or fuses rated 16 A / 250 VAC (15 A / 250 VAC in the USA and Canada).
Barco provides a range of power boxes, which meet the requirements of your fixed SLite display. Contact
Barco for more information about power boxes and power requirements for your fixed SLite display.
Power system:
It is recommended to use a TN-S power distribution system (a power distribution system with a separate neutral and grounding
conductor) in order to avoid large ground currents loops due to voltage differences in the neutral conductor. The total electrical
installation should be protected by an appropriate rated disconnect switch, circuit breakers and Ground Fault Current Interrupters.
The installation shall be done according to the local electrical installation codes. In Europe special attention should be given to EN
60364, the standard for electrical installation of buildings. In Germany VDE 0100 should be adhered to.
Disconnect device:
When the appliance inlets of the individual tiles are not accessible, the socket outlets supplying the rack shall be installed near the
equipment and be easily accessible, or a readily accessible general disconnect device shall be incorporated in the fixed wiring.
This equipment MUST be earthed:
In order to protect against risk of electric shock, the installation should be properly grounded. Defeating the purpose of the grounding
type plug will expose you to the risk of electric shock.
10
R5976575 FIXED SLITE DISPLAY 08/03/2006
Advertisement
Table of Contents
