Cycle978 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists
3.1 Overview of measuring cycle parameters
3.1.5

CYCLE978 measuring cycle parameters

PROC CYCLE978(INT S_MVAR,INT S_KNUM,INT S_KNUM1,INT S_PRNUM,REAL S_SETV,REAL S_FA,REAL
S_TSA,INT S_MA,INT S_MD,INT S_NMSP,STRING[32] S_TNAME,INT S_DLNUM,REAL S_TZL,REAL
S_TDIF,REAL S_TUL,REAL S_TLL,REAL S_TMV,INT S_K,INT S_EVNUM,INT S_MCBIT,INT _DMODE,INT
_AMODE) SAVE ACTBLOCNO DISPLOF
Table 3- 5 CYCLE978 call parameters
No. Screen form Cycle
parameters parameters
S_MVAR
1
2 Selection S_KNUM
226
1)
Meaning
Measuring version
Values: UNITS: Contour element
0 = Measure surface
TENS: Reserved
HUNDREDS: Correction target
0 = Only measurement (no correction of the WO or no tool offset)
1 = Measurement, determination and correction of the WO (see
2 = Measurement and tool offset (see
THOUSANDS: Reserved
TEN THOUSANDS: Measuring with spindle reversal
0 = Measurement without spindle reversal
1 = Measurement with spindle reversal
Correction of the work offset (WO) or basic WO or basic reference
Values: UNITS:
TENS:
0 = No correction
1 to max. 99 numbers of the work offset or
1 to max. 16 numbers of the basic offset
HUNDREDS: Reserved
THOUSANDS: Correction of WO or basic or basic reference
0 = Correction of the adjustable WO
1 = Correction of the channel-specific basic WO
2 = Correction of the basic reference
3 = Correction of the global basic WO
9 = Correction of the active WO or for G500 in last active channel-specific
basic WO
TEN THOUSANDS: Coarse or fine correction in the WO, basic WO or basic
reference
0 = Fine correction
1 = Coarse correction
S_KNUM1
6)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
)
S_KNUM
)
9)
2)
Measuring cycles