Siemens SINUMERIK 840D sl Programming Manual page 70

Measuring variants
2.2 Measure workpiece (turning)
List of the result parameters
The measuring variant "Front edge" provides the following result parameters:
Table 2- 6
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVI [0]
_OVI [2]
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
70
"Front edge" result parameters
Description
Setpoint value for measuring axis
Setpoint in 1st axis of the plane → only for
Setpoint in 2nd axis of the plane → only for
Setpoint in 3rd axis of the plane → only for
Actual value for measuring axis
Actual value in 1st axis of the plane → only for
Actual value in 2nd axis of the plane → only for
Actual value in 3rd axis of the plane → only for
Difference for measuring axis
Difference in 1st axis of the plane → only for
Difference in 2nd axis of the plane → only for
Difference in 3rd axis of the plane → only for
D number or WO number
Measuring cycle number
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
Measuring cycles