HP ProCurve 5300xl Series Management Manual page 64

Static Virtual LANs (VLANs)
Configuring VLANs
2-34
— Continued from the Previous Page —
Note: If you create an IPv4 protocol VLAN, you must also
assign the ARP protocol option to the VLAN to provide IP
address resolution. Otherwise, IP packets are not deliverable.
A "Caution" message appears in the CLI if you configure IPv4
in protocol VLAN that does not already include the arp protocol
option. The same message appears if you add or delete another
protocol in the same VLAN.
Note: SNA and DEClat protocol VLANs are not supported on
the Series 3400cl and Series 6400cl switches.
name < ascii-name-string >
When included in a vlan command for creating a new static
VLAN, specifies a non-default VLAN name. Also used to
change the current name of an existing VLAN. (Avoid spaces
and the following characters in the <ascii-name-string > entry:
@, #, $, ^, &, *, (, and ). To include a blank space in a VLAN
name, enclose the name in single or double quotes ('...' or "...").
[ voice]
Designates a VLAN for VoIP use. For more on this topic, refer
to "Voice VLANs" on page 2-49.
For example, to create a new, port-based, static VLAN with a VID of 100:
Figure 2-23. Example of Creating a New, Port-Based, Static VLAN
To go to a different VLAN context level, such as to the default VLAN:
HPswitch(vlan-100)# vlan default_vlan
HPswitch(vlan-1) _
Creates the new VLAN.
Shows the VLANs
currently configured in
the switch.
If this field is empty, a Secure Management VLAN
is not configured in the switch. Refer to "The
Secure Management VLAN" on page 2-44