Cli: Configuring 802.1D Stp - HP ProCurve 5300xl Series Management Manual

Spanning-Tree Operation
802.1D Spanning-Tree Protocol (STP)
6-24

CLI: Configuring 802.1D STP

STP Commands Used in This Section
show spanning-tree config
spanning-tree
protocol-version
forward-delay < 4 - 30 >
hello-time < 1 - 10 >
maximum-age < 6 - 40 >
priority < 0 - 65535>
ethernet < port-list >
path-cost < 1 - 65535 >
priority < 0 - 255 >
mode < norm | fast >
Viewing the Current STP Configuration.
Syntax: show spanning-tree config
Regardless of whether STP is disabled (the default), this
command lists the switch's full STP configuration, including
general settings and port settings.
When the switch is configured for 802.1D STP, this command displays infor­
mation similar to the following:
Figure 6-10. Example of the Default STP Configuration Listing with 802.1D STP
Configured at the Protocol Version
Below
page 6-25
page 6-26
page 6-26
page 6-26
page 6-26
page 6-27
page 6-27
page 6-27
page 6-27
Command Listing when
STP is the Protocol Version
(See also page 6-12)