Configuring Rip Parameters; Enabling Rip - HP ProCurve 5300xl Series Management Manual

Parameter Description
IP address The routes that a routing switch learns or advertises The routing switch
can be controlled.
loop The method the routing switch uses to prevent routing Poison reverse
prevention loops caused by advertising a route on the same
interface as the one on which the routing switch
learned the route.
• Split horizon - the routing switch does not
advertise a route on the same interface as the one
on which the routing switch learned the route.
• Poison reverse - the routing switch assigns a cost
of 16 ("infinite" or "unreachable") to a route before
advertising it on the same interface as the one on
which the routing switch learned the route.
receive Define the RIP version for incoming packets
send Define the RIP version for outgoing packets

Configuring RIP Parameters

Use the following procedures to configure RIP parameters on a system-wide
and individual VLAN interface basis.

Enabling RIP

RIP is disabled by default. To enable it, use one of the following methods.
When you enable RIP, the default RIP version is RIPv2-only. You can change
the RIP version on an individual interface basis to RIPv1 or
RIPv1-compatible-v2 if needed.
To enable RIP on a routing switch, enter the following commands:
HPswitch(config)# ip routing
HPswitch(config)# router rip
HPswitch(rip)# exit
HPswitch(config)# write memory
Syntax: [no] router rip
IP Routing Features
Configuring RIP
Default
learns and
advertises all RIP
routes on all RIP
interfaces
V2-only
V2-only
11-23