HP ProCurve 5300xl Series Management Manual page 203

The asterisk indicates
that you must reboot the
switch to implement the
configuration change
from RSTP to STP.
Figure 6-16. Changing from RSTP to STP Requires a System Reboot
3. If the Protocol Version is set to RSTP (as shown in figure 6-15), do the
following:
) to move the cursor to the Protocol Version field.
a. Press [E] ( Edit
b. Press the Space bar once to change the Protocol Version field to STP.
c. Press to return to the command line.
[Enter]
d. Press (for
[S] Save
Operation screen. you will then see a screen with the following:
e. Press (zero) to return to the Main Menu, then
[0]
switch.
f. After you reboot the switch, enter the menu command at the CLI to
return to the Main Menu, then select:
2. Switch Configuration ...
4. Spanning Tree Operation
You will then see the Spanning Tree screen with STP (802.1D) selected
in the Protocol Version field (figure 6-17).
802.1D Spanning-Tree Protocol (STP)
) to save the change and exit from the Spanning Tree
Spanning-Tree Operation
to reboot the
[6]
6-35