Subaru 2001 Outback Owner's Manual page 351

2.5 L turbo models
3.6 L models
6. Remove the oil filter with an oil filter
wrench.
7. Before installing a new oil filter, apply a
thin coat of engine oil to the seal.
8. Clean the rubber seal seating area of
the bottom of engine and install the oil
filter by hand turning. Be careful not to
twist or damage the seal.
9. Tighten the oil filter by the amount
indicated in the following table after the
seal makes contact with the bottom of
engine.
Oil filter Part
Model
color number
Black 15208AA100
2.5 L
models
Blue 15208AA12A
3.6 L
Black 15208AA031
models
CAUTION
. Never over tighten the oil filter
because that can result in an oil
leak.
. Thoroughly wipe off any engine
oil that has spilled over the
exhaust pipe and/or under-cover.
If left unremoved, the oil could
catch fire.
10. Reinstall the cover under the oil filter.
11. Pour engine oil through the filler neck.
Maintenance and service
Oil capacity (guideline):
2.5 L models: 4.2 US qt (4.0 liters, 3.5 Imp
qt)
3.6 L models: 6.7 US qt (6.3 liters, 5.5 Imp
qt)
The oil quantity indicated above is only a
guideline. The necessary quantity of oil
depends on the quantity of oil that has
Amount of
been drained. The quantity of drained oil
rotation
differs slightly depending on the tempera-
1 rotation
ture of the oil and the time the oil is left
7/8
flowing out. After refilling the engine with
rotation
oil, therefore, you must use the level
3/4
gauge to confirm that the level is correct.
rotation
12. Start the engine and make sure that no
oil leaks appear around the filter's rubber
seal and drain plug.
13. Keep the engine idling until the engine
reaches the normal operating temperature
range, as indicated by the temperature
gauge on the combination meter. After
that, check the engine oil level again. For
further details about the check procedure,
refer to "Checking the oil level" F11-12.
11-15
– CONTINUED –