Table of Contents
Advertisement
Dual Mode Chroma Keying
Dual Mode CHROMA KEY Menu
When you have selected dual mode, the CHROMA KEY menu appears as
shown below.
In this menu, select item 5 (CH) to select the appropriate chroma key.
Key 1 is identified as channel ("CH") 1, and key 2 is identified as channel 2.
The other items, 1 to 4, are the same as described in the section "Basic
Chroma Key Operations" (page 5-3).
Note, however, the following restrictions.
• In a D1 system, when carrying out dual chroma keying, for the foreground
• In a D2 system, the foreground is common to the two channels (i.e. keys).
Chroma keyer
(channel) selection
5-16
Chapter 5 Chroma Keying
of key 2 ("channel 2") it is not possible to use one of the input signals to the
CRK INPUT connectors (CH 1 to CH 4) on the rear panel of the processor.
You can only use the signal selected on the key bus.
The foreground selected for channel 1 (i.e. key 1) is also used for channel 2
(i.e. key 2).
M/E-1 CHROMA KEY
SETUP
ADJUST
VIDEO
CORRECT
MASK
CH
CH1
MODE
DUAL
Example M/E-1 CHROMA KEY menu display (dual mode)
:
KEY MASK
FRGD
:
1
MASK
:
KEY ACTIVE
ON
MASK INVERT
:
ON
COLOR CANCEL
MASK SOURCE
:OFF
WINDOW
KEY POS
:OFF
FRGD CORRECT
:OFF
INPUT SELECT
1
2
3
:OFF
: BOX
4
Advertisement
Table of Contents
