Table of Contents
Advertisement
Hardware Compatibility Matrix for Cisco Remote PHY Shelf 7200
Hardware Compatibility Matrix for Cisco Remote PHY Shelf
7200
Note
Unless otherwise specified, the hardware components introduced in a given Cisco Remote PHY Shelf 7200
Software Release are supported in all subsequent releases.
Table 20: Hardware Compatibility Matrix for the Cisco Remote PHY Shelf 7200
Cisco CMTS Platform
Cisco cBR-8 Converged Broadband Router with
Cisco IOS XE Gibraltar 16.10.1 and Later Releases
Configure Dynamic Bonding Group
Before configuring DBG, it is assumed that interface Mac domain and fiber node are already configured on
the Cisco cbr-8 router. The recommended primary channel distribution is one primary channel for contiguous
four channels, such as 0, 4, 8, 12, 16, 20, 24, 28 and so on. For more information, see DOCSIS Interface and
Fiber Node Configuration in the Cisco cBR Converged Broadband Routers DOCSIS Software Configuration
Guide.
Note
To know more about the commands referenced in this module, see the
Enable Dynamic Bonding Group
DBG is disabled by default. Use cable dynamic-bonding-group command to enable DBG as shown in the
following example:
ROUTER# configure terminal
ROUTER(config)# cable dynamic-bonding-group
ROUTER(config)# end
To configure the bonding group reclaim threshold, use cable dynamic-bonding-group reclaim-threshold
command as shown in the following example:
ROUTER# configure terminal
ROUTER(config)# cable dynamic-bonding-group reclaim-threshold percent 5% modems 6
ROUTER(config)# end
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
70
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Cisco Remote PHY Shelf 7200
Cisco Remote PHY Shelf 7200 Software 1.1 and
Later Releases
Cisco Remote PHY Shelf 7200
• PID—HA-RPHY
Cisco IOS Master Command
List.
Advertisement
Table of Contents
