Table of Contents
Advertisement
22. METER/TRACK VIEW
Here you can view the pre fader level meter and post fader
level meter. You can also use the track view display to check
whether a track contains audio events.
1
3
1. Select DisplayMode ...........[PreFaderLev, PostFaderLev,
TrkView1–8, TrkView9–16, TrkView1–16]
Select the signals that you wish to display.
Press the " " button to access the dialog box, and make
a selection. Press the "OK" button to activate your selec-
tion, or press the "Cancel" button to cancel.
PreFaderLev: Display the pre-fader level of each mixer
channel.
PostFaderLev: Display the post-fader level of each mixer
channel.
TrkView1–8, TrkView9–16, TrkView1–16: The selected
range of tracks will be displayed.
The current time location will always be in the center,
and the audio events will be shown as bars.
1a. ScaleChangeSW...........................[(5, 10, 20, 40)]
This changes the region displayed in the track view.
Each time you press the button, you will cycle through
expanding or shrinking the display in a range of 5 sec–40
sec.
The button is displayed as "
"
" when shrinking.
5sec: Display 5 seconds before and after the current loca-
tion.
10sec: Display 10 seconds before and after the current
location.
20sec: Display 20 seconds before and after the current
location.
40sec: Display 40 seconds before and after the current
location.
2
1a
" when expanding, or as
2. Snd1, 2/Mon L, R/Mst L, R .........................................
These are the level meters for "Snd1, 2" (effect send 1, 2),
"Mon L, R" (monitor L, R), and "Mst L, R" (master L, R).
"MstL, R" is also displayed at the right of the page in
[SONG/CD], [TRACK], [RECORD], [INPUT/TUNER],
and [EQ/PHASE] modes, allowing you to check the
master LR level.
3. PkHold....................................................... [0...8s, ∞]
Specify the time until the peak hold of the level meter is
cancelled.
This setting applies to the level meters of this page. Press
the "PkHold" button to access the dialog box, and make
the desired setting. Press the "OK" button to activate
your selection, or press the "Cancel" button to cancel.
0...8s: 0–8 seconds
∞: The peak hold indicator will be held forever. The hold
indicator will be cleared when you press the "PkHold"
button to access the dialog box.
133
Advertisement
Table of Contents
