Raypak XTherm Series Installation & Operating Instructions Manual page 29

WARNING: Use only the materials, vent systems
and terminations listed in Table P. DO NOT mix
vent systems of different types or manufacturers,
unless listed in this manual. Failure to comply could
result in severe personal injury, death, or substantial
property damage.
NOTE: The XTherm heater is supplied with a vent
connector that MAY require a specific vent starter
adapter to mate to certified Cat IV stainless steel
vent materials (see Table N below). This vent start-
er adapter is supplied by the vent manufacturer to
adapt to the various venting systems.
The XTherm (2505-4005) are supplied with an integral Fas-N-Seal vent connector. The installer must use a
specific vent starter adapter (supplied by the vent manufacturer).
Model No.
Air Intake Terminal
2505
3005
3505
4005
Model No.
Air Intake Terminal
2505
3005
3505
4005
Model No.
Air Intake Terminal
2505
3005
3505
4005
*D-15 Vent Terminal MUST be ordered from Raypak
Table N: Certified Stainless Steel Terminations and Adaptors - Category IV
Vent Terminal
810003447
810003488
Vent Terminal
91014TERM
91214TERM
Vent Terminal
2SVEE1090
2SVEE1290
NOTE: Installation of a stainless steel vent systems
shall adhere to the stainless steel vent manufactur-
er's installation instructions supplied with the vent
system. Please contact the vent manufacturer with
any questions.
NOTE: The following stainless steel vent manu-
facturers are certified for us on these heaters. DO
NOT use any manufacturer of stainless steel vent
systems not listed here. M&G Duravent (FasNSeal
Vent), Heat Fab (Saf-T-Vent EZ Seal) and Z Flex
(Z-Vent).
M&G Duravent – "Fas-N-Seal"
*D-15 10" 10" Fas-N-Seal
(006650)
*D-15 12" 12" Fas-N-Seal
(007001)
Heat Fab – Saf-T Vent EZ Seal
10" Saf-T-Vent
91090TEE
6" to 48" Lengths
*D-15 12" 12" Saf-T-Vent
(007001) 6" to 36" lengths
Z Flex – "Z Vent"
2SVSRTX10
6" to 36" Lengths
2SVSRTX12
6" to 36" Lengths
29
Vent Pipe Vent Adapter
6" to 36"
None Required
6" to 36"
Vent Pipe Vent Adapter
91001MAD
91201MAD
Vent Pipe Vent Adapter
10" Z Vent
2SVDSA10
12" Z Vent
2SVDSA12