Modes Of Operation; Ecp Mode; Zone Trigger Mode - Honeywell IntelliPath Series Installation And Setup Manual

Modes of Operation

The communicator provides four modes of operation so it can be used with various types of
control panels, as summarized below.
ULC

ECP Mode

 This mode is for Honeywell control panels that support ECP communication
 The communicator connects to the control panel's keypad terminals and provides 2-way
communication with the control panel using ECP messaging
 The control panel treats the communicator as an ECP device, so ensure to program the
control panel with the communicator's device address
 Reports are sent in Contact ID format
 The communicator also supports two hardwire zone trigger inputs (zones 6 and 7)
UL/ULC

Zone Trigger Mode

 This mode is for use with control panels that do not support ECP communication
 The communicator provides six input zones
 Each zone can be configured for +V, –V, or EOLR triggering
UL/ULC: For the LTE-I, only the V+ inverted, V– non-inverted, and EOL options have been
evaluated.
 Each zone can be programmed for inverted operation, delayed reporting, and restoral
reporting
 Zone 1 input can distinguish between pulsed and steady signals and report fire or burglary
alarms respectively
 Zone 1 can also be programmed to report LYNX panic (if used with LYNX control)
UL/ULC: This feature has not been evaluated by UL.
 Reports are sent in ADEMCO High-Speed format
UL/ULC
Only ECP Mode has been approved for ULC Commercial Fire Installations. ECP and Zone
Triggers modes are approved for ULC Commercial Burglary Installations.
 Opening and Closing ring back is fully supported.

For the LTE-I, only the V+ inverted, V– non-inverted, and EOL options have been
evaluated.
Opening and Closing ring back is supported by the control panel's digital dialer.
3
Section 1: General Information