Honeywell IntelliPath Series Installation And Setup Manual page 28

LTE-I Installation and Setup Guide
PROMPTS
Invert Zn6 Y/N
37
(N)_
Restore Zn6 Y/N
38
(Y)_
Delay Zn6 (secs)
39
(00)_
Enable Zn7 Y/N
40
(N)_
Zn7 Trigger Type
41
(V+)_
Invert Zn7 Y/N
42
(N)_
Restore Zn7 Y/N
43
(Y)_
Delay Zn7 (secs)
44
(00)_
Prompts 45-51 appear only if communication path includes IP.
Use DHCP Y/N
45
(Y)_
NIC IP Address:
46
255.255.255.255_
Subnet Mask:
47
255.255.255.255_
Gateway IP Addr:
48
255.255.255.255_
DNS Serv IP Addr:
49
255.255.255.255_
Enable Pwr Save
50
(N)_
OPTIONS
[Y], [N]
Inverts the alarm and normal states of the zone 6 trigger; otherwise
uses normal input signal.
Enables restore reporting for zone 6.
[Y], [N]
[01-15] Defines the reporting delay in seconds for zone 6.
[00] = no delay UL/ULC: Must be set to 00.
[Y], [N] Enables alarm reporting for zone 7.
If [N], skip to Prompt 45: "Use DHCP."
 (V+) Selects the triggering method for this zone input.
 (V–)
Press the [space] key to scroll choices.
 (EOLR)
UL/ULC: V+ must be set as inverted and V– as
non-inverted.
Inverts the alarm and normal states of the zone 7 trigger; otherwise,
[Y], [N]
uses normal input signal.
[Y], [N]
Enables restore reporting for zone 7.
[01-15]
Defines the reporting delay in seconds for zone 7.
[00] = no delay
UL/ULC: Must be set to 00.
[Y], [N] Dynamically allocates the IP addresses (recommended); then skip to
Prompt 50: "Enable Pwr Save".
If [N], uses fixed IP addresses.
12 digit: Enter the 4-part address for this device. The 4 parts of the address
xxx.xxx.xxx.xxx must be separated by spaces (displayed as periods in Review mode).
12 digit: Enter the 32-bit address mask used to indicate the portion (bits) of the
xxx.xxx.xxx.xxx IP address that is being used for the subnet address. The 4 parts of the
address must be separated by spaces (displayed as periods in Review
mode).
12 digit: Enter the 4-part address assigned to the Gateway. The 4 parts of the
xxx.xxx.xxx.xxx address must be separated by spaces (displayed as periods in Review
mode).
12 digit: Enter the 4-part IP address assigned to the DNS (Domain Name
xxx.xxx.xxx.xxx System) server. The 4 parts of the address must be separated by
spaces (displayed as periods in Review mode).
[Y], [N] To meet the 24 hour UL battery backup requirement, choose "Y" to
enable this feature. If this causes connectivity problems with certain
routers or switches, then choose "N" and wire the communicator so it is
plugged into a UL listed UPS.
UL: Must be set to Y.
DESCRIPTION
24