Connecting the unit
6.1.4 Attaching the hygiene plate
INFORMATION
6.2 Making the electrical connection
NOTICE
22
The hygiene plate is enclosed with the unit.
Before the electrical connection is made, guide the lines through the openings
in the hygiene plate.
d
Image: Attaching the hygiene plate
a Hygiene plate
b Rubber buffer
1. Remove the rubber buffer from the housing.
2. Press the hygiene plate onto the housing.
3. Fasten the hygiene plate with the rubber buffer to the housing.
Risk of property damage from wrong supply voltage
• Prior to connecting, measure the supply voltage and check the voltage set
on the transformer inside the unit.
The unit must be connected in accordance with the information on the
nameplate and the instructions of this manual.
Wiring diagram
The wiring diagram is included with the unit.
Electrical installation work
Electrical installation work on the electric system and the unit may only
be performed by a specialist company, which is approved by the
electric utility company in the particular region. The applicable regional
regulations, standards and guidelines must be observed, as well as the
connection conditions imposed by the electric utility company
responsible.
Installation instructions
a
c
b
c Threaded cable connection
d Gland for waste water pipe