Mounting; Wiring - SMC Networks EX500 Series Instruction Manual

Mounting

The mounting and removing methods of each SI unit are as shown below.
Supply/exhaust block assembly,
end plate R, power block, or other
EX9 series general purpose output block
M3 18 : 2 pcs.
( Hexagon socket head
cap screw ( with spring washer ))
NOTE
Hold with hands so that there will be no gap between units and tighten the screws.
Be sure to tighten each screw by specified tightening torque.
( Tightening torque: 0.6Nm )
Dimensions when general purpose output block is connected
13
PWR PWR
COM
0
1
PWR
EX500
series
L dimensions
No. of output block stations 1
L1 [mm] 83 104
L2 [mm] 72
L3 [mm] 67
The above dimensions indicate when one unit of power block ( width: 21mm ) is
Note
combined. For details, refer to the instruction manuals, technical data, etc. of EX9
series general purpose output block.
34
Power block or EX9 series
general purpose output block
Tie-rod: 4 pcs.
SI unit for general purpose
output block ( EX500-Q
L1
L2
L3
0 0 0 0 0 0 0
1 1 1 1 1 1 1
1.5 Mounting hole for:
M4 places
2 3 4 5 6
125 146 167 188
93 114 135 156 177
88 109 130 151 172

Wiring

Output wiring
Connect output devices to the output connectors.
EX9-OET1/EX9-OET2/EX9-OEP1/EX9-OEP2 output connectors
M12, 5-pin, socket
Connector on cable side: Ex; OMRON Corp.,
Model No.
Pin No.
Output connector
02 )
Power supply
1
2 Output ( OUT1 )
3
4 Output ( OUT 0 )
5
Two outputs are available with only output connector No. 0.
NOTE
Mount a waterproof cap to each unused connector. The proper use of waterproof
cap can achieve IP65 Enclosure. ( Tightening torque for M12: 0.1Nm )
7 8
209 230
198 219
193 214
XS2H, XS2G. etc., and Franz Binder GmbH,
Series 713 and 763.
EX9-OET2/EX9-OEP2
NPN output
Output connector Output connector
No.0 No.1
Power supply
( DC24V ) ( DC24V )
NC Output ( OUT 1 )
Power supply
NC NC
Output ( OUT 1 ) Output ( OUT 0 )
NC NC
1 2
5
4 3
EX9-OET1/EX9-OEP1
PNP output
Output connector
No.0 No.1
NC NC
NC
Power supply
( GND ) ( GND )
Output ( OUT 1 )
NC NC
NC: Not connected
35