Skoda Octavia III 2013 Workshop Manual page 158

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Screw in detent part - VAS 5161/6- with interlocking fork - VAS
5161/5- into the outer threaded bore on the guide plate for the
FSI engine - VAS 5161/19C- .
– Press the assembly cartridge - VAS 5161/8- down; at the same
time, turn the knurled screw on the assembly cartridge - VAS
5161/8- to the right so that the nibs lie between the valve col‐
lets.
– Move the knurled screw to and fro slightly, by doing so the
valve collets are pressed apart and are installed in the assem‐
bly cartridge.
– Release the pressure fork - VAS 5161/2- .
– Remove assembly cartridge - VAS 5161/8- .
– Pull off valve stem seal with extractor for valve stem seal -
3364- .
– If the valve stem seal extractor - 3364- cannot be used due to
space constraints, drive out the roll pin -arrow- with a mandrel
and remove the final impacter.
– Set the lower part of the valve stem seal extractor - 3364- onto
the valve stem seal.
– Insert the mandrel -1- into the bore in the lower part of the
extractor.
– Attach an assembly lever to the extractor and remove the
valve stem seal -arrow-.
150
Rep. gr.15 - Cylinder head, valve gear