Skoda Octavia III 2013 Workshop Manual page 15

1.2.9 General notes on the injection system
Ignition system - Assembly overview
♦ The engine control unit is equipped with self-diagnosis. Before
repairs and also for fault finding, first of all interrogate the event
memory. Also check the vacuum hoses and connections (un‐
metered air).
♦ Fuel hoses in the engine compartment must only be secured
with spring-type clips ⇒ Electronic catalogue of original parts
"ETKA" . The use of clamp or screw-type clips is not permis‐
sible.
♦ A minimum voltage of 11.5 V is required for perfect functioning
of the electrical components.
♦ Do not use sealants containing silicone. Traces of silicone el‐
ements drawn in by the engine are not burnt in the engine and
damage the lambda probe.
♦ Certain inspections may cause the control unit to detect and
store a fault. It is therefore necessary to interrogate the event
memory after having completed all inspections and repairs,
and if necessary delete ⇒ Vehicle diagnostic tester.
Safety precautions when working on the injection system
⇒ page 6 .
1.2.10 General notes on the ignition system
♦ Switch off the ignition before disconnecting and connecting the
battery, as this may damage the engine control unit.
♦ The engine control unit and further components are equipped
with self-diagnosis; inspect ⇒ Vehicle diagnostic tester
♦ A minimum voltage of 11.5 V is required for perfect functioning
of the electrical components.
♦ Certain inspections may cause the control unit to detect and
store a fault. It is therefore necessary to interrogate the event
memory after having completed all inspections and repairs,
and if necessary delete ⇒ Vehicle diagnostic tester.
Safety measures ⇒ page 2
Setting data, spark plugs ⇒ Maintenance ; Booklet Octavia III .
1.2.11 General instructions for charge air sys‐
tem
WARNING
When undertaking all installation work, particularly in the en‐
gine compartment because of its cramped construction, please
observe the following:
♦ Lay lines of all kinds (e.g. for fuel, hydraulic fluid, cooling
fluid and refrigerant, brake fluid, vacuum) and electrical
lines in such a way that the original line guide is re-estab‐
lished.
♦ Ensure that there is adequate free access to all moving or
hot components.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 341 .
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
7
1. Denomination