Tracer Td7 Operator Interface; Tracer™ Tu - Trane Tracer TD7 User Manual

Controls
Figure 4. LED locations
Table 8. LED behavior
LED
Powered. If the Marquee LED is green solid,
the UC800 is powered and no problems exist.
Low power or malfunction. If the Marquee
Marquee
LED is red solid, the UC800 is powered, but
LED
there are problems present.
Alarm. The Marquee LED blinks Red when an
alarm exists.
The TX LED blinks green at the data transfer
rate when the UC800 transfers data to other
devices on the link.
LINK,
MBUS, IMC
The Rx LED blinks yellow at the data transfer
rate when the UC800 receives data from
other devices on the link.
The LINK LED is solid green if the Ethernet
link is connected and communicating.
Ethernet
The ACT LED blinks yellow at the data
Link
transfer rate when data fl ow is active on the
link.
The Service LED is solid green when pressed.
Service For qualifi ed service technicians only. Do not
use.
NOTICE:
Electrical Noise!
Maintain at least 6 inches between low-voltage (<30V)
and high voltage circuits. Failure to do so could result in
electrical noise that could distort the signals carried by
the low-voltage wiring, including IPC.
14
UC800 Status

Tracer TD7 Operator Interface

Information is tailored to operators, service technicians,
and owners.
When operating a chiller, there is specifi c information
you need on a day-to-day basis—setpoints, limits,
diagnostic information, and reports.
Day-to-day operational information is presented at the
display. Logically organized groups of information—
chiller modes of operation, active diagnostics, settings
and reports put information conveniently at your
fi ngertips.
Tracer™ TU
The RTHD operator interface allows for daily operational
tasks and setpoint changes. However, to adequately
service chillers Tracer™ TU service tool is required.
(Non-Trane personnel, contact your local Trane offi ce
for software purchase information.) Tracer TU adds a
level of sophistication that improves service technician
effectiveness and minimizes chiller downtime. This
portable PC-based service-tool software supports service
and maintenance tasks, and is required for software
upgrades, confi guration changes and major service
tasks.
Tracer TU serves as a common interface to all Trane®
chillers, and will customize itself based on the properties
of the chiller with which it is communicating. Thus, the
service technician learns only one service interface.
The panel bus is easy to troubleshoot using LED sensor
verifi cation. Only the defective device is replaced. Tracer
TU can communicate with individual devices or groups
of devices.
All chiller status, machine confi guration settings,
customizable limits, and up to 100 active or historic
diagnostics are displayed through the service-tool
software interface.
LEDs and their respective Tracer TU indicators visually
confi rm the availability of each connected sensor, relay,
and actuator.
Tracer TU is designed to run on a customer's laptop,
connected to the Tracer control panel with a USB cable.
Your laptop must meet the following hardware and
software requirements:
• 1 GB RAM (minimum)
• 1024 x 768 screen resolution
• CD-ROM drive
• Ethernet 10/100 LAN card
• An available USB 2.0 port
• Microsoft® Windows® XP Professional operation
system with Service Pack 3 (SP3) or Windows 7
Enterprise or Professional operating system (32-bit or
64-bit)
• Microsoft .NET Framework 4.0 or later
RLC-SVU006A-E4