Position Send; 1Transmitting A Dsc Position Send Call; 2Receiving A Dsc Position Send Call - Standard Horizon QUANTUM GX2360S Owner's Manual

7.8.3 Position Send

The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the QUANTUM to send the position.
To transmit a Position Send Call, you must setup the QUANTUM DSC
Individual / Position Call Directory with the name of the vessel(s) or per-
son and the MMSI of the DSC radio you wish to send your position to. To
setup this directory refer to section 7.7.1 Setting up the Individual / Posi-
tion Call Directory.
7.8.3.1 Transmitting a DSC Position Send Call
1. Press the [ CALL/SET ( MENU )] key. The "DSC OP-
ERATION" menu will appear in the display.
2. Turn the CHANNEL selector knob to select the "POS
SEND."
3. Press the [ CALL/SET ( MENU )] key to select the In-
dividual directory.
4. Turn the CHANNEL selector knob to select a name
in the directory.
5. Press the [ CALL/SET ( MENU )] key to send your po-
sition to the selected vessel.
6. To exit the mode, select "EXIT" and press the
[ CALL/SET ( MENU )] key.
7.8.3.2 Receiving a DSC Position Send Call
When another vessel transmits their vessels location to the QUANTUM the
following will happen:
1. A ringing sound will be produced when the call is received.
2. Press the [ 16/9 ] key to stop ringing
3. The position from the vessel sending it's position will be shown on the dis-
play of the radio and also transferred to any Standard Horizon GPS Chart
plotter if connected.
GX2360S
NOTE
Page 49