Position Send; Setting Up Position Send Ringer; Transmitting A Dsc Position Send Call - Standard Horizon MATRIX GX3000S Owner's Manual

11.9 POSITION SEND

The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the GX3000S to send the position.
11.9.1 Setting up a Position Send Ringer
The GX3000S has the capability to turn off the Position Send ringer.
1. Press and hold down the [ CALL ( MENU )] key until
" Radio Setup
2. Turn the CHANNEL selector knob to select "
Setup " menu.
3. Press the [ ENT ] key, then select "
the CHANNEL selector knob.
4. Press the [ ENT ] key.
5. Turn the CHANNEL selector knob to select "
Send ."
6. Turn the CHANNEL selector knob to select "
7. Press the [ ENT ] key to store the selected setting.
8. To exit this menu and return to radio operation mode
press the [ 16/9 ] key.
If you wish to return to enabling the ringer tone, just re-
peat the above procedure, turning the CHANNEL selec-
tor knob to select "

11.9.2 Transmitting a DSC Position Send Call

Pre-Programmable Calling
1. Press the [ CALL ( MENU )] key.
The " DSC Operation
appear in the display.
2. Turn the CHANNEL selector
knob to select the "
3. Press the [ ENT ] key to select the Individual directory.
4. Turn the CHANNEL selector knob to select a name
in the directory, then press the [ ENT ] key.
5. Press the [ ENT ] key to send your position to the se-
lected vessel.
Page 56
" menu appears.
On " in step "6" above.
" menu will
POS Send ."
DSC
DSC Beep " with
POS
Off ."
GX3000S