Printer Maintenance; Things To Prepare; Cleaning Schedule - Oki Pro1040 Maintenance Manual

⿟

Printer Maintenance

This section describes how to clean the various parts of the printer.

Things to Prepare

Prepare the following things for cleaning the various parts of the printer.
z Wiper (or equivalent product)
z Cleaning fluid (isopropyl alcohol)
z Water or neutral cleanser
z Cotton swabs

Cleaning Schedule

Check the condition of the equipment at the start and end of operations, and clean it as needed.
Cleaning guidelines are noted below.
Unwinder
Printer
Note
* :
z Clean the feed path (including rollers) and fuser unit when changing the width of the roll paper.
Streaks may appear when printing, particularly after changing the paper width from narrow to wide, because of the traces (paper
dust etc.) left along the width of the paper.
When you change the width of the roll paper, check the conditions of the fuser unit and feed path and clean them, and then
restart printing.
z Wear gloves to clean if you are using cleaning fluid.
z Refer to the "Setup Guide" regarding the names and functions of parts.
Surface
Flange
Side-Guide-8Inch
Tension Bar
Guide-Side-Roller-F
Unwinder Paper Guide
Sheet Guide
Roll Paper Guide
F0 Roller Unit
Sensor Cover(Upper)
Sensor Cover(Lower)
F1 Roller Unit
Cutter Unit
Surface
Paper Guide
Feed Unit
Sensor Cover(Lower)
Sensor Cover(Upper)
Exit Unit
LED Heads
Fuser Unit
Everyday
- 73 -
Printer Maintenance
Cleaning schedule
When dirt is
noticeable
－
○
○
○
○
○
○
○
○
○
○
－
○
－
○
○
○
○
－
－
－
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○ *