Network Interface Specifications - Oki Pro1040 Maintenance Manual

Specifications

Network Interface Specifications

z <Basic specifications>
Network protocol
• TCP/IP protocols
• EtherTalk protocols
z <Connectors>
1000BASE-T/100 BASE-TX/10 BASE-T (automatic switching, simultaneous usage not possible)
Note
z 1000BASE-T is disabled in the default factory settings.
To use 1000BASE-T, do the following settings on the control panel.
[Admin Setup] > Input password > [Network Setup] > [Gigabit Network] > Set [Enable].
z <Cables>
Unshielded twisted pair cable with RJ-45 connector (category 5e or better)
z <Connector pin layout>
z <Interface signals>
Pin Signal
no. name
1 TRD+(0) Sending and receiving data 0 (+)
2 TRD-(0) Sending and receiving data 0 (-)
3 TRD+(1) Sending and receiving data 1 (+)
4 TRD+(2) Sending and receiving data 2 (+)
5 TRD-(2) Sending and receiving data 2 (-)
6 TRD-(1) Sending and receiving data 1 (-)
7 TRD+(3) Sending and receiving data 3 (+)
8 TRD-(3) Sending and receiving data 3 (-)
Function
- 104 -