Hardware Identification Chart - Stamina Magnetic Resistance Recumbent Bike 15-4760 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
56
57
58
59
60
63
64
72
73
74
78
79
80
81
82
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Carriage Bolt (M8 x 1.25 x 65mm)
Bolt, Button Head (M8 x 1.25 x 55mm)
Bolt, Button Head (M10 x 1.5 x 125mm)
Bolt, Round Head (M6 x 1 x 15mm)
Bolt, Round Head (M6 x 1 x 35mm)
Bolt, Hex Head (M6 x 1 x 35mm)
Screw, Round Head (M5 x 0.8 x 10mm)
Nylock Nut (M10 x 1.5)
Acorn Nut (M6 x 1)
Acorn Nut (M8 x 1.25)
Arc Washer (M6)
Arc Washer (M8)
Lock Washer (M6)
Lock Washer (M8)
Washer (M10)
5
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
2
2
2
3
8
4
4
2
4
2
7
2
7
2
2