Advertisement
➓
Magnet
Front cover
Switch
Screws
Hatch panel
Push plate
Adjusting the Interlock Switch
Make sure the push plate is positioned at the center of the
hole for the interlock switch when the hatch panel is
closed. If it is misaligned, then it must be adjusted by loos-
ening the screws for the front cover and tilting the side
frames slightly to the left or right, with the hatch panel
kept closed.
Make sure the interlock switch is pressed down fully when
Left side panel A
Screws:
silver, M4 x 8 mm
➀ Attach the left side panels A and B.
➁ Attach the right side panels A and B.
Hatch panel
Hole
Push plate
Left side panel B
The screws are loosened.
the hatch panel is closed. If the switch is not pressed,
loosen the screws for the push plate and adjust the posi-
tioning.
How to Close the Hatch Panel
Lower the hatch panel, lift the handles slightly, and posi-
tion so that the bottom edge of the hatch panel straddles
the protrusion at the top of the front panel.
Right side panel A
Side panel
Side frame
Right side panel B
9
Advertisement
