Tunturi E6 Owner's Manual page 8

Hide thumbs Also See for E6:
Table of Contents

Advertisement

Remove the power cord from the power outlet,
wait for 1 minute and then restart. If the error
message does not disappear, please contact your
Tunturi dealer.
T R A N S P O R T A N D S T O R A G E
Please follow these instructions when carrying
and moving the cycle about, because lifting it
incorrectly may strain your back or risk other
accidents:
Always switch the power off and unplug
N O T E !
the power cord before you start moving the
equipment around!
Stand behind the equipment. Grip the seat with
one hand and the handlebar with the other, and set
your foot on the rear support. Tilt the equipment
so that it rests on its transport wheels. Wheel the
equipment to move it, on these transport wheels.
Lower the equipment while holding on to the
handlebar and remain behind the equipment all
the time.
To prevent the equipment malfunctioning, store in
a dry place with as little temperature variation as
possible and protected from dust.
M A I N T E N A N C E
The equipment requires very little maintenance.
Check, however, from time-to-time that all screws
and nuts are tight.
After exercising, clean the equipment with a
soft, absorbent cloth. Do not use solvents. Sweat
may cause corrosion: we recommend therefore that
you protect all metal surfaces outside the plastic
covers with tefl on or car wax.
Never remove the equipment's protective casing.
The electromagnetic brake forms a magnetic
fi eld that may damage the mechanism of a watch,
or the magnetic identifi cation strip on a credit
or cash card, should they come into immediate
contact with the magnets. Never attempt to detach
or remove the electromagnetic brake!
The electromagnetic brake is based on
electromagnetic resistance; resistance level is
electronically measured and shown as watt reading
on the display. Due to the measurement system,
your Tunturi ergometer need not be re-calibrated
when assembled, serviced and used according to
this Owner's Manual.
If the equipment is not used for a period
of time, the transmission belt may become
temporarily distorted. This can lead to a sensation
of slightly uneven pedaling. However, after a few
minutes of use the effect disappears as the belt
returns to its original form.
8
If the equipment does not function
N O T E !
properly during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also the
nature of the problem, conditions of use and
purchase date. Despite continuous quality control,
defects and malfunctions caused by individual
components may occur in the equipment. In most
cases it's unnecessary to take the whole equipment
in for repair, as it's usually suffi cient to replace the
defective part.
D I M E N S I O N S
Length.........................
96 cm
Width .........................
69 cm
Height.........................
124 cm
Weight ........................
35 kg
Due to our continuous policy of product
development, Tunturi reserves the right to change
specifi cations without notice.
The instructions must be followed carefully
N O T E !
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment
and maintenance instructions described herein.
Changes or modifi cations not expressly approved
by Tunturi Oy Ltd will void the user's authority to
operate the equipment!
We wish you many enjoyable trainings with
your new Tunturi training partner!

Advertisement

Table of Contents
loading

Table of Contents