Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Preinstallation
4.7
Emissions during Operation
Photochemical solutions may discharge gases into the air. Some gases have a very low
odor level. In unfavorable cases this may result in bad odor although the maximum
working site concentration (max. value) has not yet been reached. Bad odors may be
avoided by sufficient room ventilation and/or air conditioning.
4.8
Air Conditioning
4.8.1
Air Conditioning System
During operation the minilab produces heat (details see
Machines with gas laser:
d-lab.2
d-lab.2plus
Machines with solid state laser:
d-lab.2 select
d-lab.2 basic
d-lab.2 (70mm)
d-lab.2plus select
d-lab.2plus basic
d-lab.2plus (70mm)
netlab.2plus basic
Therefore we recommend to install air conditioning, which guarantees for the required
room climate (room temperature and humidity) (see
Operating conditions
).
The laser exhaust (only d-lab.2 with gas laser, Type 8060/260, and d-lab.2plus with gas
laser, Type 8060/261) can be extracted separately (see
the laser exhaust duct
)
Regular exchange of the air volume in the work rooms is necessary.
Note
The wet section of the Paper Processor is sealed. The exhaust air generated here is
negligible. Hence, the connection of an air exhaust is not necessary in this area.
4.8.2
Room ventilation
Ventilation should be sufficient so that the maximum working site concentration is not
exceeded.
Observe national regulations!
AgfaPhoto
Technical data)
Type 8060/260
Type 8060/261
Type 8060/803 and Type 8060/804
Type 8060/270 and Type 8060/272
Type 8060/157 + 8060/255
Type 8060/813 and Type 8060/814
Type 8060/271 and Type 8060/273
Type 8060/158 + 8060/255
Type 8060/505
Room ventilation
sections
Connection of an exhaust on
appr. 5.500 kcal/h
appr. 4.640 kcal/h
and
2005-05-01 / PN 04100_01
Operation Site
11
Advertisement
Table of Contents
