Fiat 500 Owner's Handbook Manual page 88

To install an ISOFIX child restraint
system, hook the two metal anchors
A fig. 68 located on the back of the
rear seat cushion, at the junction with
the backrest then, after removing the
parcel shelf, secure the upper belt
(provided with the child restraint
system) to the special anchor B fig. 69
located behind the seat backrest, in the
lower part.
68
69
86
An example of an Universal Isofix child
restraint system for weight group 1 is
shown in fig. 70.
DVDF0S050c
70
DVDF0S051c
IMPORTANT The figure is indicative
and for assembly purposes only.
Fit the child restraint system
according to the instructions, which
must be included.
NOTE When a Universal ISOFIX child
restraint system is used, only ECE
R44 "ISOFIX Universal" (R44/03 or
further upgrades) type-approved child
restraint systems can be used.
The other weight groups are covered
by the specific Isofix child restraint
system, which can be used only if
specifically designed, tested and
approved for this car (see car list
provided with the child restraint
system).
The Universal Isofix "Duo Plus" child
restraint system and the special
"G 0/1" seat are available from
Lineaccessori Mopar
For any further details on
installation/use, refer to the instruction
DVDF0S049c
manual provided with the child restraint
system.
.
®