Nameplates For Hazardous Area Installations; Device Identification - Siemens SITRANS F Series Operating Instructions Manual

10.Connect the sensor connection and the sensor cable.
11.Restore the flexible strap around all wires.
12.Assemble and tighten the cable gland.
13.Remove the O-ring from lid.
14.Reinstate the lid and screw in until the mechanical stop. Wind back the lid by one turn.
15.Mount the O-ring by pulling it over the lid and tighten the lid until you feel friction from the
O-ring on both sides. Wind the lid by one quarter of a turn to seal on the O-ring.
16.Reinstate and tighten the lid lock screw.
5.3

Nameplates for hazardous area installations

5.3.1

Device identification

Each part of the FC330 Coriolis flowmeter has three nameplate types showing the following
information:
● product identification
● product specifications
● certificates and approvals
Note
Identification
Identify your device by comparing your ordering data with the information on the product
and specification nameplates.
With compact versions, the transmitter and sensor product identifications are both given as
'Coriolis flowmeter SITRANS FC330'.
With remote versions, the transmitter is identified as 'Coriolis transmitter SITRANS FCT030'
and the sensor as 'Coriolis sensor SITRANS FCS300'.
FC310 (From firmware 4.0)
Operating Instructions, 06/2018, A5E44036384-AA
5.3 Nameplates for hazardous area installations
Connecting
49