Blower Wheel Replacement; Wiring Diagrams - Southbend Marathoner Gold ES/20SC Operator's Manual

E C
LECTRIC ONVECTION

BLOWER WHEEL REPLACEMENT

To replace the blower wheel, do the following:
1. Remove racks and rack guides.
2. Remove rear air baffle in front of blower wheel.
3. Loosen the two square heads on blower wheel hub.
4. Pull blower wheel from motor shaft. If blower wheel is difficult to pull off, use puller disk (available from
Southbend as part number 1179100).

WIRING DIAGRAMS

A wiring diagram is located on the side of the control panel assembly (as shown on page 42). Wiring
diagrams also appear on the following pages of this manual. Which wiring diagram is appropriate depends
on the voltage and type of controls.
Index of Wiring Diagrams
Page Number Voltage and Type of Controls
44 208-240 Volt Models with Standard Controls
45 480 Volt Models with Standard Controls
46 415/240 Volt Models with Standard Controls
47 380/220 Volt Models with Standard Controls
48 208-240 Volt Models with Cycle/Cook & Hold Controls
49 480 Volt Models with Cycle/Cook & Hold Controls
50 415/240 Volt Models with Cycle/Cook & Hold Controls
51 380/220 Volt Models with Cycle/Cook & Hold Controls
52 208-240 Volt Models with Programmable or Rack Timer Controls
53 480 Volt Models with Programmable or Rack Timer Controls
54 415/240 Volt Models with Programmable or Rack Timer Controls
55 380/220 Volt Models with Programmable or Rack Timer Controls
O
PERATOR
O
VENS
' M 1181958
S ANUAL
T
ROUBLESHOOTING
P 43
AGE