Table of Contents
Advertisement
Memorise and recall program
The generator allows you to memorize and subsequently
recall up 30 welding programs.
Memorise a program
1. Set the process and the desired welding profile (as
specified in § 4.0 and 5.0);
2. Press for more than three seconds the key 32 (entry
in the memorise state is accompanied by long "beep"
and the first memory location P01on the display );
3. If you want to memorize the program in another
memory location, turn the encoder to the right
(increasing the number of memory location) to the
memory location where you want to memorize the
program;
4. Press for more than three seconds the key 32. At this
point the program is stored in desired memory
location (the memorise is accompanied by long
"beep" and the text "MEM" on the display).
The exit from this state is possible in three ways:
1. Memorize of program;
2. Inactivity of key 32 and encoder (10 seconds);
3. Short press of key 32.
The memory locations can be overwritten. during the
memorise state all keys (with the exception of the key 32
and the encoder) are disabled and therefore you can not
change any parameter.
Memorized program recall
1. Press for more than three seconds the key 31 (entry
in the recall program state is accompanied by long
"beep" and the first memory location P01on the
display );
2. Turn the encoder to the right (increasing the number
of memory location) to the program memory location
that you want to recall;
3. Press for more than three seconds the key 31. At this
point desired program is loaded (the recall is
accompanied by long "beep").
The exit from this state is possible in three ways:
1. Recalling a program;
English
AUTOMATIC SEQUENCE
NOTE
2. Inactivity of key 31 and encoder (10 seconds);
3. Short press of key 31.
During the recall state all keys (with the exception of the
key 31 and the encoder) are disabled and therefore you
can not change any parameter.
Welding programs management
The welding and the relative parameters set up can be
done manually through various commands.
When first switched on the generator is set up in a
predefined state and with welding parameters value that
allows to work immediately.
Moreover, the generator is provided with a memory that
saves the set up configuration for each welding mode
(MMA, TIG HF, TIG Lift) before it is turn off.
Therefore, the worker will be able to see the last set up
when the generator is switched on again.
The use of the remote control
The power source allows the use of the
remote controls. After connecting the
remote control to the female connector on
the front of the machine you can choose
whether to work in local or remote mode
by means of vertical scroll key (Ref. 14 - Picture 1 Page
6.).
Pressing vertical scroll key (Ref. 14 - Picture 1 Page 6)
when the remote control is not connected has no effect.
In electrode welding mode, after activating the remote
function you can adjust welding current continuously
from minimum to maximum using the remote control.
The display will show the current set with the control.
In electrode mode you can select manual remote
control only.
In TIG welding mode you can select between two
10
NOTE
NOTE
NOTE
English
Advertisement
Table of Contents
