Table of Contents
Advertisement
20
Ascent Slope
By pressing function keys 31 e 32 the luminous indicator
is position at 21 - Picture 1 Page 6.); then by activating
the knob 30, the time to reach the nominal current
welding in TIG modality is set up. The value range is
between 0 and 10 seconds.
21
Nominal Current Welding
By pressing function keys 31 e 32 the luminous indicator
is position at 22 - Picture 1 Page 6.); then by activating
the knob 30, the value for the nominal current welding
for alvl the available modalities is set up. The value
range is between 5A and 220A in electrode mode; 5A
and 220A.
22
Reduced Current/ Basic Current.
By pressing function keys 31 e 32 the luminous indicator
is position at 23 - Picture 1 Page 6.); then by activating
the knob 30, the value for the reduced current in the
Four Times mode is set up. If the TIG mode is pressed
(either Two or Four Times) the pulsation of the basic
current is set up. The value range is between the
nominal current welding and the 10% of that same value.
English
23
Spot Time
By pressing function keys 31 e 32 the luminous indicator
is position at 24 - Picture 1 Page 6.); then by activating
the knob 30, the time length for the spot impulse is set
up in seconds. TIG The value range is between 0,1 and
10 seconds.
Wave-shaped Balance
By pressing function keys 31 e 32 the luminous indicator
is position at 25 - Picture 1 Page 6.); then by activating
the knob 30, the balance of the different wave shapes
pressed on TIG is set up.
The wave-shaped balance can be set up in a value
ranging from 1 and 99 for frequencies between 0,3 Hz
and 15 Hz. The range decreases linearly for higher
frequencies (up to 250 Hz) up to range between 30 and
70 (See - Picture 2 Page 6.).
Wave-shaped balance
Picture 2.
WAVE-SHAPED BALANCE
Descent Slope
By pressing function keys 31 e 32 the luminous indicator
is position at 27 - Picture 1 Page 6.); then by activating
8
24
25
English
Advertisement
Table of Contents
