If You Cannot Set The Sensors From The Printer Driver - Oki Pro1040 User Manual

If You Cannot Set the Sensors from the Printer Driver

If you cannot set the sensors from the printer driver, then set them from the control panel.
Black mark sensor
Configure the sensor type
Media form = Continuous Paper (Black Mark)
Die-cut Label (Black Mark)
Continuous Label (Black Mark)
Configure the paper size
Paper Size = Custom
X Dimension = Input the "label width"
For die-cut labels (black marks):
Paper length = Input the "label length"
Gap Length = Input the "gap length"
Otherwise:
Black mark interval = Input the "length between
Confirm the sensor position
black marks"
Execute sensor calibration
Sensor calibration → Execute
Configure the sensor type
Media form = Die-cut Label (Gap)
Configure the paper size
X Dimension = Input the "label width"
Y Dimension = Input the "label length"
Gap Length = Input the "gap length"
- 37 -
Calibrating the Sensor
Gap sensor
Paper Size = Custom